Dealing with Pines, Continued

Last summer I posted about removing a bunch of volunteer pines. It was hot sweaty work on a black flag day.  Later in the summer I cut a bunch more.

To my dismay, I saw that some (not all) of the pines have coppiced, i.e., they've sent out sprouts around the former main stem.  They're down but they're not out.  Glyphosate may be called for once things start growing again in the spring.

The biggest of the trees I cut down last summer were about two inches in diameter.    Shown below is one of the bigger stems.

This size is easily manageable with loppers.  When pines are neglected for a longer period of time, it's a different story.

I have some pines that, unnoticed by me, have grown up too close to a pole barn and they are now threatening the structure (or actually damaging it).  They have been growing on the back side for the most part.  In the years since I've had the property, they have grown to something twenty feet tall and up to eight or nine inches at the base.  These trees are more like 14-16 years old.

Felling them has not been too difficult so far, but things are crowded in the area where they are growing, so some have to be dropped and removed to make room to cut down others.  They were big enough that I wanted to buck them into firewood-length pieces as I hauled them out.

 Once they were on the ground, I used the Stihl chainsaw and timber jack to part them out.

You can see that the one growing closest to the back of the pole barn was so close I had to cut it off a couple of feet up from the ground.  At the base there wasn't enough room to get the chainsaw bar behind it. You can also see that the needles still look green and reasonably fresh--even though this picture was taken a couple of months after the tree was cut down.

Once the main stems were cut into 18-inch pieces, I hauled them out in a wheelbarrow.

The work is still ongoing.  I plan to split them into firewood; although pine is not highly valued in the east compared to hardwood, it has some value.  As previously noted, I also have a lot of tulip poplar on deck for next winter.  It is not much higher on the BTU-per-cord chart than pine (and may even be lower; some sites indicate that southern pine yields over 20 million BTUs per cord, which approaches 80-90% of what oak provides).  Some suggest that pine causes heavy creosote deposits--the rounds above exuded drops of sticky sap along all of the ring lines soon after cutting--but if seasoned and used in a hot fire, it can burn as cleanly as anything else.