Bumper Crop of Black Walnuts

Last year (2016) I got no black walnuts.  North Georgia had a severe drought in the late summer and early fall; although I had some nuts on the trees in July, by the end of August they had all aborted.

This year was different.  A lot of nuts were downed in early September by Irma.  As I mentioned in September, I went ahead and cracked some of them right away to see if they were okay and they were.  Lesson learned, however:  The nuts had not cured.  I left the container of nuts shown in the Irma post out at room temperature to see what would happen, and after a week or so the nut meats molded.

I didn't go back for the rest of the Irma walnuts because (as noted previously) it was a total pain trying to remove the husks.  It probably took 30-60 seconds of hammering to get them off each nut.

The remainder of the crop started to drop in October.  In all, I probably got about 20 gallons' worth off of my two trees, and I left many more on the ground unharvested.  I just couldn't get to them all in time.

It takes me about an hour to process five gallons.  I have gotten better at it, but it's still labor intensive.  First I knocked off the hulls with a hammer. The fully ripe ones were much easier to de-husk.  I had some husk fly larvae but not many; perhaps last year's failed crop cut down on the population some. Then I swirled them in water in a bucket, using both the water stream out of the faucet and the nuts themselves to remove remaining husk.  I did about three or four rinses, ending up with what you see here.  That's about clean enough, though I have seen cleaner shells.  People pressure wash them or do many more rinsing cycles to get them cleaner.  They don't have to be works of art.

I haven't cracked these yet--that's actually the most labor-intensive step in processing--but they are ready to go.  They'll be good in the shell for a year or two.